azteeg-x3-using-sd-card [2013/09/05 16:29] deezmaker |
azteeg-x3-using-sd-card [2013/11/23 12:40] (current) jit corrected spelling of auto0.g |
||
---|---|---|---|
Line 3: | Line 3: | ||
To use the SD card feature **without a USB connection** (otherwise no need to do this step) to the Azteeg X3 board, you need to change a jumper to switch the power source of the main chip to use the 12v power supply labeled as "INT". This is found by removing the top cover sheild carefully and changing the power jumper from USB to INT. | To use the SD card feature **without a USB connection** (otherwise no need to do this step) to the Azteeg X3 board, you need to change a jumper to switch the power source of the main chip to use the 12v power supply labeled as "INT". This is found by removing the top cover sheild carefully and changing the power jumper from USB to INT. | ||
- | {{:bukobotv2:img_3039.jpg?direct&300|}}{{:bukobotv2:img_3040.jpg?direct&300|}} | + | {{:bukobotv2:img_3039.jpg?direct&400|}}{{:bukobotv2:img_3040.jpg?direct&400|}} |
===== Step 1 - Generate your G-Code ===== | ===== Step 1 - Generate your G-Code ===== | ||
Line 23: | Line 23: | ||
After inserting the mircoSD card into the Azteeg X3 board, you have 2 options to start running the G-code: | After inserting the mircoSD card into the Azteeg X3 board, you have 2 options to start running the G-code: | ||
- | 1 - If you named your file "auot0.g", then simply turning on or reseting your Bukobot 3D printer should begin the print. | + | 1 - If you named your file "auto0.g", then simply turning on or resetting your Bukobot 3D printer should begin the print. |
2 - If you connect through Repetier or Pronterface, you can bring up the SD card manager and select the file from a list to start. | 2 - If you connect through Repetier or Pronterface, you can bring up the SD card manager and select the file from a list to start. |