azteeg-x3-using-sd-card
|
azteeg-x3-using-sd-card [2013/09/05 16:30] deezmaker |
azteeg-x3-using-sd-card [2013/11/23 12:40] (current) jit corrected spelling of auto0.g |
||
|---|---|---|---|
| Line 23: | Line 23: | ||
| After inserting the mircoSD card into the Azteeg X3 board, you have 2 options to start running the G-code: | After inserting the mircoSD card into the Azteeg X3 board, you have 2 options to start running the G-code: | ||
| - | 1 - If you named your file "auot0.g", then simply turning on or reseting your Bukobot 3D printer should begin the print. | + | 1 - If you named your file "auto0.g", then simply turning on or resetting your Bukobot 3D printer should begin the print. |
| 2 - If you connect through Repetier or Pronterface, you can bring up the SD card manager and select the file from a list to start. | 2 - If you connect through Repetier or Pronterface, you can bring up the SD card manager and select the file from a list to start. | ||
azteeg-x3-using-sd-card.1378416604.txt.gz · Last modified: 2013/09/05 16:30 by deezmaker
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
