bukobot-marlin-configuration [Bukobot 3D Printer Instructions & Docs]

skip to content

User Tools

Login

Site Tools

Recent changes
Media Manager
Sitemap

You are here: Bukobot 3D Printer » bukobot-marlin-configuration

bukobot-marlin-configuration

====== Bukobot Marlin Firmware / Configuration Files ======

Azteeg X1 and X3 electronics shipped with a Bukobot from Deezmaker come programmed with Marlin pre-configured. If for some reason you need to reprogram it, here are the three configurations used. Choose the appropriate firmware for your electronics.
^Model^  Azteeg X1  ^  Azteeg X3  ^
|Bukobot 8 Duo|  X  |{{:marlin_x3.zip|Marlin RC2 for X3 with dual extruder}}|
|Bukobot 8 Vanilla|{{:marlin_x1.zip|Marlin RC2 for X1}}|{{:marlin_x3_single.zip|Marlin RC2 for X3 with single extruder}}|
|Bukobot 8 Green|:::|:::|
|Bukobot Mini Green|:::|:::|

For upgrading proceedure, see: [[software-to-install#printer-firmware|Software to Install : Printer Firmware]]

bukobot-marlin-configuration.1354821141.txt.gz · Last modified: 2012/12/06 13:12 by deezmaker

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported

CC Attribution-Share Alike 3.0 Unported