cleaning-up-printed-parts [Bukobot 3D Printer Instructions & Docs]

====Cleaning up printed parts====


==Widening a hole===

Before widening any hole, make sure it's okay to do so.  Some holes shouldn't be widened beyond a certain point because they will hold a self-tapping screw that has no nut on the other end.  If you widen such a hole too much, you may have to re-print the part, or figure out some other way of doing it.

If a hole is to be widened until a given screw will slide freely through it, generally the quickest way is to use a drill bit.

But drilling can be hazardous.  Drilling safely requires a vise or similar to hold the work piece, but many of the printed parts don't fit well in a vise.  If you simply hold the work piece in your hand, the bit might grab it and spin it around and generally create mayhem, so don't do this.

Fortunately, the plastic material used here is soft enough so that a safer alternative can be used.

Install your drill bit on your drill, or hold it in a vise or some other device to keep it from spinning.  Then simply screw your plastic part onto the bit, by hand, just as if you were screwing a nut onto a screw:

{{wiki:jitsbuild:hole-widening.png}}

When the part is fully onto the bit, twirl it around a few times with your finger.  Then pull it off, while slowly turning it in the same direction.

This makes a clean hole, is often quicker than using a rotating bit, and is definitely safer.

This method also works with thin pieces of wood, such as the base of the hot end.

It doesn't work as well with really large parts, or really large holes, but it should suffice for all of the holes you might need to widen while building a Bukobot.

  * M2.5 screw:
  * M3 screw:
  * M4 screw:
  * M5 screw:
User Tools

Site Tools

Page Tools
