cleaning-up-printed-parts
|
cleaning-up-printed-parts [2012/12/10 06:40] jit |
cleaning-up-printed-parts [2012/12/11 20:59] (current) jit |
||
|---|---|---|---|
| Line 16: | Line 16: | ||
| {{wiki:jitsbuild:hole-widening.png}} | {{wiki:jitsbuild:hole-widening.png}} | ||
| - | When the part is fully onto the bit, twirl it around a few times with your finger. Then pull it off, while slowly turning it in the same direction. | + | When the part is fully onto the bit, twirl it around a few times with your finger (don't hurt your finger). Then pull it off, while slowly turning it in the same direction. |
| This makes a clean hole, is often quicker and more accurate than using a rotating bit, and is definitely safer. | This makes a clean hole, is often quicker and more accurate than using a rotating bit, and is definitely safer. | ||
cleaning-up-printed-parts.1355143229.txt.gz · Last modified: 2012/12/10 06:40 by jit
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
