electrical-safety [Bukobot 3D Printer Instructions & Docs]

skip to content

User Tools

Login

Site Tools

Recent changes
Media Manager
Sitemap

You are here: Bukobot 3D Printer » electrical-safety

electrical-safety


[A section on mains electrical safety measures needs to be added here. It is //seriously// not cool to leave the mains terminals exposed. Strain relief should also be added on the mains cable (which can perhaps be as simply as using a cable tie through the power supply grill). Last but not least, consider bridging neutral and ground to increase safety in areas where the neutral line is not grounded (such as you can see here: http://reprap.org/wiki/RepRapPro_Mendel_power_supply ) - otherwise you have a floating supply. I think the Power Supply could warrant its own section on the page.]

electrical-safety.txt · Last modified: 2012/12/10 10:21 by jit

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported

CC Attribution-Share Alike 3.0 Unported