heated-bed-preparation
|
heated-bed-preparation [2012/12/12 23:15] jit |
heated-bed-preparation [2012/12/30 09:20] (current) jit |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| - | It would probably save time and hassle if the platform was fully prepared for printing, on top and underneath, //before// the platform is added to the machine. However, nobody has actually done this, //and// fully documented it on this wiki. Most of the rest of the build is mechanically obvious, compared to the thermal complications of the heated platform. There is some disagreement as to the best methods. For these reasons, the "jit's build" documentation largely skips over the preparation of the heated platform, at least so far. | + | It will save time and hassle if the platform is fully prepared for printing, on top and underneath, //before// the platform is added to the machine. But it can be done later; the platform is not difficult to remove and re-attach. |
| Complete, successful platform implementations should be documented here. There may be a number of ways of doing things, and they are all welcome on this page. Please contribute. | Complete, successful platform implementations should be documented here. There may be a number of ways of doing things, and they are all welcome on this page. Please contribute. | ||
| Line 87: | Line 87: | ||
| Attach the bed to the platform. The top of the bed still needs to be done. If the bed had already been leveled, it needs to be leveled again. | Attach the bed to the platform. The top of the bed still needs to be done. If the bed had already been leveled, it needs to be leveled again. | ||
| - | |||
| - | ------------------------- | ||
heated-bed-preparation.1355375723.txt.gz · Last modified: 2012/12/12 23:15 by jit
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
