jitsbuild-v1-to-v2-cable-spacers
|
jitsbuild-v1-to-v2-cable-spacers [2013/11/18 13:26] jit created |
jitsbuild-v1-to-v2-cable-spacers [2013/11/18 13:28] (current) jit |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| {{wiki:jitsbuild:v2upgrade-xcarriage-beforeextruders.png}} | {{wiki:jitsbuild:v2upgrade-xcarriage-beforeextruders.png}} | ||
| - | If your v1 Bukobot is sufficiently different from this one for some reason, or if you're just generally paranoid, you can print {{wiki:jitsbuild:synchromesh-spacer- v1-to-v2-shimmable.stl|this shimmable spacer}} instead. (Or print both kinds, just to be sure.) An M3 button-head screw goes down through the top part, through as many M3 washers as you need, then through the bottom part. A washer and nut goes underneath to hold it all together. | + | If your v1 Bukobot is sufficiently different from this one for some reason, or if you're just generally paranoid, you can print {{wiki:jitsbuild:synchromesh-spacer-v1-to-v2-shimmable.stl|this shimmable spacer}} instead. (Or print both kinds, just to be sure.) An M3 button-head screw goes down through the top part, through as many M3 washers as you need, then through the bottom part. A washer and nut goes underneath to hold it all together. |
| [[jitsbuild-v1-to-v2| Back to jit's build: upgrading to v2 extruders]] | [[jitsbuild-v1-to-v2| Back to jit's build: upgrading to v2 extruders]] | ||
jitsbuild-v1-to-v2-cable-spacers.1384802768.txt.gz · Last modified: 2013/11/18 13:26 by jit
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
