jitsbuild-wires [2013/02/20 07:26] buildrob |
jitsbuild-wires [2014/01/25 17:44] (current) jit |
||
---|---|---|---|
Line 2: | Line 2: | ||
[[jitsbuild-extruder|Prev: Extruder]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-failure-conditions|Next: Failure conditions to watch out for]] | [[jitsbuild-extruder|Prev: Extruder]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-failure-conditions|Next: Failure conditions to watch out for]] | ||
+ | |||
+ | //This page pertains to the Bukobot v1. Some portions may be useful to v2 owners. For more information, see [[jitsbuild|here]].// | ||
If there are any motors or endstops that aren't installed right now, install them. The adjustment procedure for the Y axis endstop is [[jitsbuild-y-axis#adjust endstop|here]] (read the whole procedure before starting); the X axis endstop is adjusted in a similar way. All of the endstops will probably need to be adjusted at least once more after this. | If there are any motors or endstops that aren't installed right now, install them. The adjustment procedure for the Y axis endstop is [[jitsbuild-y-axis#adjust endstop|here]] (read the whole procedure before starting); the X axis endstop is adjusted in a similar way. All of the endstops will probably need to be adjusted at least once more after this. |