jitsbuild-x-leftend
|
jitsbuild-x-leftend [2013/02/20 06:34] buildrob |
jitsbuild-x-leftend [2014/01/25 17:38] (current) jit |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| [[jitsbuild-x-carriage|Prev: X carriage]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-x-rightend|Next: X right end]] | [[jitsbuild-x-carriage|Prev: X carriage]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-x-rightend|Next: X right end]] | ||
| + | |||
| + | //This page pertains to the Bukobot v1. Some portions may be useful to v2 owners. For more information, see [[jitsbuild|here]].// | ||
| =====Parts===== | =====Parts===== | ||
| Line 17: | Line 19: | ||
| //whosawhatsis says:// | //whosawhatsis says:// | ||
| > I punch out the bridge and then run my pocket knife along the inner edge of the circle around where the nut goes to taper it and allow the nut to slide in a big easier, but that's it. The underside of the UHMW nut trap should not need any additional cleaning. | > I punch out the bridge and then run my pocket knife along the inner edge of the circle around where the nut goes to taper it and allow the nut to slide in a big easier, but that's it. The underside of the UHMW nut trap should not need any additional cleaning. | ||
| + | |||
| + | //ncorison says:// | ||
| + | >I used a 5/8" deep well automotive socket lined with emery cloth to flatten the bottom surface and clean up the sides and a smaller one to clean up the sides of the top hole. | ||
| {{:wiki:jitsbuild:cleanup1.png?800}} | {{:wiki:jitsbuild:cleanup1.png?800}} | ||
jitsbuild-x-leftend.1361363676.txt.gz · Last modified: 2013/02/20 06:34 by buildrob
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
