y-axis-braces [Bukobot 3D Printer Instructions & Docs]

====== Y Axis Braces ======

The Y axis uses a metal-on-metal screw-in joint which is an extremely strong joint in the important Y-Z direction (i.e., keeping the Y axis perpendicular to the Z axis) but without bracing is quite weak in the X-Y rotational direction (i.e., keeping the Y axis perpendicular to the X axis). This means that any small knock can put the Y axis out of alignment.

This page provides some printable braces that can be used to keep the Y axis locked in position.

** Requirements **
  * 2 of each of the following printed braces {{:y-axis-brace.zip}}
  * 10 M5x10mm button head screws
  * 10 M5 slim/half nuts

**Instructions**
  - Use a file to make sure you have a flat edge on the non-rounded side (it doesn't need to be dead square just flat - the pieces have been intentionally designed with some play in the channel guides so you can align manually), 
  - Insert M5 half/slim nuts and M5x10mm screws. 
  - Slot the pieces into each side of Y axis and frame bottom. 
  - Carefully align and position your Y-axis. 
  - Tighten Y-axis screws.
  - Slide up the printed pieces and lock them into place using a right angle allen key.
  - You are rock steady!

The smaller X-axis frame bottom pieces are not as important - they just stop the Y-axis moving to the left or right. However you can insert the frame bottom pieces without pulling apart your whole frame just by dropping the M5 slim nuts into the Misumi channel and then screwing the piece into the nut from above.

Also don't forget to put M5 washers underneath the heads of the two M5x8mm Y-axis screws (inside the Y axis channel) to ensure they don't bottom out in the frame bottom channel. If the screws do bottom out you won't get a proper metal-on-metal join even when you fully tighten the screw.
User Tools

Site Tools

Page Tools
