bukobot-v2-y-ends [Bukobot 3D Printer Instructions & Docs]

skip to content

User Tools

Login

Site Tools

Recent changes
Media Manager
Sitemap

You are here: Bukobot 3D Printer » bukobot-v2-y-ends

bukobot-v2-y-ends

===== Bukobot V2 Y Ends =====
 Clean the rods by applying a small amount of WD-40 (spray it on a rag and wipe with that), and then wiping them completely dry with a clean cloth. Be careful to keep the WD-40 spray away from all other parts (it can damage them). Be very thorough about getting all of the WD-40 off of the rods, as it's very bad for bearings. For more information see [[http://www.bukobot.com/wiki:clean-and-lubricate|Clean and lubricate]]. 

{{:bukobotv2:img_4510.jpg?direct&900|}}

{{:bukobotv2:img_4538.jpg?direct&900|}}

bukobot-v2-y-ends.1375731560.txt.gz · Last modified: 2013/08/05 14:39 by deezmaker

Page Tools

Show page
Old revisions
Backlinks
Back to top

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported

CC Attribution-Share Alike 3.0 Unported