bukobot-v2-y-ends [Bukobot 3D Printer Instructions & Docs]

===== Bukobot V2 Y Ends =====
 Clean the rods by applying a small amount of WD-40 (spray it on a rag and wipe with that), and then wiping them completely dry with a clean cloth. Be careful to keep the WD-40 spray away from all other parts (it can damage them). Be very thorough about getting all of the WD-40 off of the rods, as it's very bad for bearings. For more information see [[http://www.bukobot.com/wiki:clean-and-lubricate|Clean and lubricate]]. 

{{:bukobotv2:img_4500.jpg?direct&900|}}
{{:bukobotv2:img_4510.jpg?direct&900|}}
{{:bukobotv2:img_4538.jpg?direct&900|}}

1
2
3
4
5
6
===== Bukobot V2 Y Ends =====
 Clean the rods by applying a small amount of WD-40 (spray it on a rag and wipe with that), and then wiping them completely dry with a 
clean cloth. Be careful to keep the WD-40 spray away from all other parts (it can damage them). Be very thorough about getting all of 
the WD-40 off of the rods, as it's very bad for bearings. For more information see [[http://www.bukobot.com/wiki:clean-and-lubricate|C
lean and lubricate]]. 
{{:bukobotv2:img_4500.jpg?direct&900|}}
{{:bukobotv2:img_4510.jpg?direct&900|}}
{{:bukobotv2:img_4538.jpg?direct&900|}}
X

User Tools

Site Tools

Page Tools