host-slicing-settings
|
host-slicing-settings [2014/02/08 17:25] whosawhatsis [Host & Slicing Settings] |
host-slicing-settings [2014/04/16 16:06] (current) whosawhatsis |
||
|---|---|---|---|
| Line 34: | Line 34: | ||
| * X/Y Travel Speed: 100-355mm/sec (150mm/sec recommended) | * X/Y Travel Speed: 100-355mm/sec (150mm/sec recommended) | ||
| * X/Y Extruding Speeds: Max about 200mm/sec (tested), (100mm/sec average recommended) | * X/Y Extruding Speeds: Max about 200mm/sec (tested), (100mm/sec average recommended) | ||
| - | * Extruder Retract Speed: 25mm/minute or less (20mm recommended) | + | * Extruder Retract Speed: 25mm/sec or less (20mm recommended) |
| * Z axis speed: 250mm/minute (4mm/sec) or less (200mm/minute recommended) | * Z axis speed: 250mm/minute (4mm/sec) or less (200mm/minute recommended) | ||
| * Bukobot Build Volume: 200mm X 200mm X 200mm (8" inches cube), platform center: X:100mm, Y:100mm | * Bukobot Build Volume: 200mm X 200mm X 200mm (8" inches cube), platform center: X:100mm, Y:100mm | ||
host-slicing-settings.1391901927.txt.gz · Last modified: 2014/02/08 17:25 by whosawhatsis
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
