jitsbuild-inventory
|
jitsbuild-inventory [2013/01/01 16:51] jit |
jitsbuild-inventory [2014/01/25 17:37] (current) jit |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| [[jitsbuild-tools|Prev: Tools]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-x-carriage|Next: X carriage]] | [[jitsbuild-tools|Prev: Tools]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-x-carriage|Next: X carriage]] | ||
| + | |||
| + | //This page pertains to the Bukobot v1. Some portions may be useful to v2 owners. For more information, see [[jitsbuild|here]].// | ||
| Compare the parts you received with the [[http://bukobot.com/bukobot-parts-list|official parts list]]. If you have the Duo kit, you should have twice as many of certain parts. | Compare the parts you received with the [[http://bukobot.com/bukobot-parts-list|official parts list]]. If you have the Duo kit, you should have twice as many of certain parts. | ||
| + | |||
| + | === Sheet of cardboard? === | ||
| + | |||
| + | If your Bukobot has a heated bed, you may have received some material for use as insulation on the underside of that bed. In some kits this is a sheet of cardboard, eight inches square. (Actually the correct term is corrugated paperboard; "cardboard" is what they make cards from.) Don't throw this away; it's not just packing material. | ||
| + | |||
| + | === On the Azteeg controller board === | ||
| Check your Azteeg controller board. Compare with the images below. Do you have the driver boards? A few people didn't get them. | Check your Azteeg controller board. Compare with the images below. Do you have the driver boards? A few people didn't get them. | ||
| Line 16: | Line 24: | ||
| The Azteeg X1 uses the same driver boards, but only four of them. | The Azteeg X1 uses the same driver boards, but only four of them. | ||
| + | |||
| + | Also check that there is an extra four-conductor connector soldered onto the underside of the controller board. It is connected to the Z axis motor connector. (It's not visible in the image above.) | ||
| + | |||
| + | === On the heated bed === | ||
| + | |||
| + | If you have the heated bed, check that its thermistor is present. It's on the underside, in the middle: | ||
| + | |||
| + | {{wiki:jitsbuild:heated-bed-thermistor.jpg?800}} | ||
| + | |||
| + | (In this image, its leads haven't been trimmed yet, and it hasn't been covered with tape yet. And the thermistor should be bent farther down into the hole.) | ||
| + | |||
jitsbuild-inventory.1357080692.txt.gz · Last modified: 2013/01/01 16:51 by jit
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
