jitsbuild-x-rightend [Bukobot 3D Printer Instructions & Docs]

**jit's build:  X right end**

(Go back up to [[jitsbuild|jit's build]])

{{wiki:jitsbuild:x-right-kit.png}}

Clean up this part as before.

Add a few more parts from the synchromesh cable kit:

{{wiki:jitsbuild:x-right-subassembly1.png}}

{{wiki:jitsbuild:x-right-subassembly2.png}}

Note that the idler ring (pulley) has a lip on one side that prevents the bearing from passing all the way through it.  Position the ring/bearing combination so that this lip is facing toward the other printed part.  This will prevent the ring from falling off and rolling away, in the unlikely event that the ring starts to shift off the bearing.

Set this assembly aside.


//The contents of this page may be re-used under any of the following licenses:  The [[http://creativecommons.org/licenses/by-sa/3.0/|Creative Commons Attribution-ShareAlike 3.0 Unported License (CC BY-SA 3.0)]], or the [[http://www.gnu.org/copyleft/fdl.html|GNU Free Documentation License (GFDL, version 1.2 or later)]].//
User Tools

Site Tools

Page Tools
