jitsbuild-x-rightend
|
jitsbuild-x-rightend [2012/12/11 20:53] jit |
jitsbuild-x-rightend [2014/01/25 17:39] (current) jit |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| [[jitsbuild-x-leftend|Prev: X left end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-backend|Next: Y back end]] | [[jitsbuild-x-leftend|Prev: X left end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-backend|Next: Y back end]] | ||
| + | |||
| + | //This page pertains to the Bukobot v1. Some portions may be useful to v2 owners. For more information, see [[jitsbuild|here]].// | ||
| + | |||
| =====Parts===== | =====Parts===== | ||
| - | Parts in [[bukobot-parts-list#x-end-right-idle|bag 16]]. | + | Parts in [[bukobot-parts-list#x-end-right-idle|bag 16]]. (Your Z slide parts may be different than shown here at the right; you don't need those right now, so don't worry about them.) |
| {{wiki:jitsbuild:x-right-kit.png?800}} | {{wiki:jitsbuild:x-right-kit.png?800}} | ||
| Line 10: | Line 13: | ||
| =====Clean Part===== | =====Clean Part===== | ||
| - | Clean up this part as before, including the two small holes for the Z slide screws. (If you were an early adopter, and have four small holes, don't widen those holes.) | + | Clean up this part as before, including the two small holes for the Z slide screws (3 mm). (If you were an early adopter, you may have four small holes instead.) |
| =====Add Parts===== | =====Add Parts===== | ||
jitsbuild-x-rightend.1355280794.txt.gz · Last modified: 2012/12/11 20:53 by jit
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
