jitsbuild-y-frontend [Bukobot 3D Printer Instructions & Docs]

======jit's build:  Y front end======

[[jitsbuild-y-backend|Prev:  Y back end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-carriage|Next:  Y carriage]]

=====Parts=====

Parts in bag 13.

{{wiki:jitsbuild:y-frontend-kit.png?800}}

The items at the top come from the synchromesh cable kit (bag 11).

Not shown in the image above:  the Y axis foot.  See the last image below for that.

=====Clean Part=====

Start by cleaning up the large printed plastic part.

As with the Y back end, check that the screws and nuts fit.  Also widen the two large holes in the Y axis foot if necessary.

=====Assemble Part=====

Assemble as shown:

Top view:

{{wiki:jitsbuild:y-frontend-topview.png}}

The lip on the idler ring is on the bottom.  The big washer goes under the bearing.  You might actually need two washers there, but this can wait until a later step.

Bottom view, showing the Y axis foot:

{{wiki:jitsbuild:y-frontend-bottomview.png?800}}



[[jitsbuild-y-backend|Prev:  Y back end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-carriage|Next:  Y carriage]]

//The contents of this page may be re-used under any of the following licenses:  The [[http://creativecommons.org/licenses/by-sa/3.0/|Creative Commons Attribution-ShareAlike 3.0 Unported License (CC BY-SA 3.0)]], or the [[http://www.gnu.org/copyleft/fdl.html|GNU Free Documentation License (GFDL, version 1.2 or later)]].//
User Tools

Site Tools

Page Tools
