jitsbuild-y-frontend [Bukobot 3D Printer Instructions & Docs]

======jit's build:  Y front end======

[[jitsbuild-y-backend|Prev:  Y back end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-carriage|Next:  Y carriage]]

=====Parts=====

Parts in [[bukobot-parts-list#y-end-front-idle|bag 13]].

{{wiki:jitsbuild:y-frontend-kit.png?800}}

The items at the top come from the synchromesh cable kit ([[bukobot-parts-list#synchromesh-cable-system|bag 11]]).

Not shown in the image above:  the Y axis foot.  See the last image below or [[bukobot-parts-list##y-end-front-idle|here]] for that.

=====Clean Part=====

Start by cleaning up the large printed plastic part.

As with the Y back end, check that the screws and nuts fit.  Also widen the two large holes in the Y axis foot if necessary.

=====Assemble Part=====

Assemble as shown:

Top view:

{{wiki:jitsbuild:y-frontend-topview.png}}

The lip or flange on the idler ring is on the bottom.  The big washer goes under the bearing.  You might actually need two washers there, but this can wait until a later step.

Bottom view, showing the Y axis foot:

{{wiki:jitsbuild:y-frontend-bottomview.png?800}}



[[jitsbuild-y-backend|Prev:  Y back end]] < [[jitsbuild| Up to Jitsbuild]] > [[jitsbuild-y-carriage|Next:  Y carriage]]

//The contents of this page may be re-used under any of the following licenses:  The [[http://creativecommons.org/licenses/by-sa/3.0/|Creative Commons Attribution-ShareAlike 3.0 Unported License (CC BY-SA 3.0)]], or the [[http://www.gnu.org/copyleft/fdl.html|GNU Free Documentation License (GFDL, version 1.2 or later)]].  Nothing on any of these pages is there to tell you what to do, only what other people have already done.//
User Tools

Site Tools

Page Tools
